Bosch Dishwasher Error Code E24: Causes and Safe Fixes
Quick answer
E24 on a Bosch dishwasher means the dishwasher is not draining properly. According to Bosch, the usual causes are a blocked filter, a blocked drain pump or a loose drain pump cover, a kinked or clogged drain hose, a clogged air gap, or a new garbage disposal whose knockout plug was never removed. In many cases, cleaning the filter and the pump area and straightening the drain hose clears the code. If E24 comes back after these checks and a reset, the drain pump itself may need attention.
Safety first
- Disconnect power before you reach into the dishwasher. Turn the dishwasher off and unplug it, or switch off its circuit breaker, before removing the filter or the drain pump cover.
- Wear protective gloves. Broken glass and sharp debris can collect in the pump area.
- Do not use chemical drain cleaners or bleach in the dishwasher. Bosch warns they can damage rubber seals and pump components. Clear blockages by hand.
- Keep towels nearby. Standing water will be in the bottom of the tub.
Read our full Safety Disclaimer before you start.
How to confirm it is a drain problem
Bosch lists these typical signs that go along with E24:
- water pooling in the bottom of the tub after a cycle;
- the dishwasher pausing or stopping unexpectedly during a cycle;
- unusual gurgling or humming noises.
Before you order any part, write down your full model number (E-Nr.) and production number (FD). On Bosch dishwashers, the rating plate is inside the door. See How to Find Your Model Number.
Safe checks to fix E24
- Turn off and disconnect power. Switch the dishwasher off, then unplug it or turn off the breaker.
- Clean the filter. Pull out the bottom rack. Remove the filter as described in your owner’s manual and wash it under running water with mild soap and a soft brush. Do not use anything abrasive.
- Remove standing water. Wearing gloves, soak up the water in the bottom of the tub with a sponge.
- Clean the drain pump area. The drain pump cover sits under the filter. Remove it as your manual describes, take out any debris, including broken glass, and check that the pump impeller can move freely. Bosch notes that on some models the cover is removed with a manual screwdriver; never use an electric one.
- Reinstall the pump cover until it clicks. A loose cover can trigger the error. Then reinstall the filter so it locks in place.
- Check the drain hose. Make sure the drain hose behind the dishwasher or under the sink is not kinked, sharply bent, or crushed. Bosch also suggests checking the inlet hose for kinks or damage and making sure the siphon (sink drain) connection is sealed.
- New garbage disposal? If the drain hose connects to a garbage disposal that was recently installed, make sure the knockout plug was removed from the disposal’s dishwasher inlet. Bosch lists a forgotten knockout plug as a possible cause of E24.
- Check the air gap and drain hose for clogs. If you have an air gap on the sink, check it for debris. Bosch’s steps are to turn off the appliance, disconnect the drain hose into a bucket, clear any debris, and reconnect it. If you are not comfortable working with under-sink connections, leave this step to a technician.
- Reset and test. Restore power. Bosch’s reset steps: press and hold Reset (on some models labeled “Reset 4 Sec.”) or Start for about 4 seconds. The dishwasher pumps out the remaining water, which takes about a minute, and the cycle is canceled. Then open the door and press On/Off. Finally, run a rinse cycle to check whether it drains.
Still showing E24?
If the code returns after you have cleaned the filter and pump area, confirmed the cover clicks into place, and cleared the hose, the problem may be a faulty drain pump or a broken impeller. Bosch recommends a technician in that case. Stop here if you see water leaking under the dishwasher, smell burning, or are unsure about any step.
[TECHNICIAN_CTA]
Likely replacement part: drain pump
When E24 keeps returning after every cleaning step, the part to suspect next is the drain pump. Bosch notes the pump impeller can break, and AppliancePartsPros lists the Bosch drain pump as a fix for E24/E25 and “will not drain” symptoms. Bosch uses different pumps on different models, so check that the part matches your exact model number before you buy.
[PART_LINK:drain pump]
Example: Bosch genuine drain pump, part number 00620774, was listed at $71.51 on AppliancePartsPros.com when we checked on November 20, 2026. Prices change; the retailer’s page shows the current price and whether it fits your model.
Replacing a drain pump means disconnecting the dishwasher from power and water and working underneath or inside the unit. If you have not done this kind of repair before, consider having a technician install it.
Related Bosch codes and problems
- Bosch Dishwasher Error Code E15: Bosch says the safety switch has detected water in the base of the dishwasher and the leak protection system is active. Bosch advises turning off the water supply and contacting Bosch Customer Support.
- Bosch Dishwasher Error Code E25: Bosch’s U.S. support page gives the same causes and checks as E24: a blocked drain pump, a loose pump cover, or a kinked or clogged hose.
- Dishwasher Not Draining: a general guide for all brands.
FAQ
What does E24 mean on a Bosch dishwasher?
It means the dishwasher is not draining properly. Bosch lists a blocked filter or drain pump, a loose pump cover, a kinked or clogged drain hose, a clogged air gap, and an un-removed garbage disposal knockout plug as possible causes.
Can I just reset the dishwasher to clear E24?
A reset cancels the cycle and pumps out remaining water, but if the cause is still there, the code is likely to come back. Do the cleaning checks first, then reset and run a rinse cycle to test.
What is the difference between E24 and E25?
Both point to drainage. Bosch’s U.S. error code page gives the same guidance for both. Bosch’s Malaysia support page describes E24 as a drainage obstruction, such as a blocked filter or kinked hose, and E25 as a jammed drain pump impeller or a pump cover that is not clicked into place.
Can I pour drain cleaner into the dishwasher?
No. Bosch advises against commercial drain cleaners and bleach because they can damage rubber seals and pump components. Clear the blockage by hand.
When should I call a technician?
Call one if E24 returns after you have cleaned the filter and pump, checked that the cover clicks in, and cleared the hose; if the impeller looks broken; or if there is a leak, a burning smell, or anything you are unsure about.
Need a hand?
If the safe checks did not fix it, a professional can diagnose the pump and replace the right part for your model.
[TECHNICIAN_CTA]
Disclosure: some links in this article are affiliate links. If you buy a part or book a service through them, we may earn a commission at no extra cost to you. Learn more.
Sources
- Bosch (U.S.), Bosch Dishwasher Error Code E24: https://www.bosch-home.com/us/owner-support/dishwashers/error-codes/e24
- Bosch (U.S.), Dishwasher Error Codes (E15, E24, E25): https://www.bosch-home.com/us/en/c/spotlight/blta5a02e4f244618c3/owner-support/error-codes/dishwashers
- Bosch (U.S.), Cleaning Your Dishwasher Pump: https://www.bosch-home.com/us/owner-support/get-support/support-selfhelp-dishwashers-cleaning-dishwasher-pump
- Bosch (U.S.), How to Reset the Dishwasher: https://www.bosch-home.com/us/en/c/post-purchase/blt40e4d070968e5594/owner-support/get-support/how-to-reset-the-dishwasher-or-stop-a-wash-cycle
- Bosch (Malaysia), Dishwasher Not Draining, E24 and E25: https://www.bosch-home.com.my/en/c/spotlight/bltf81f598efaa53cd4/services/get-support/dishwasher/dishwasher-is-not-draining
- Bosch dishwasher installation instructions (model number and rating plate location): https://media3.bosch-home.com/Documents/9001955705_A.pdf
- AppliancePartsPros, Bosch 00620774 Dishwasher Drain Pump (price checked November 20, 2026): https://www.appliancepartspros.com/bosch-pump-drain-620774-ap5326239.html