Side cutaway of a dishwasher showing water collected in the base pan lifting the leak-protection float

Bosch Dishwasher Error Code E15: Causes and Safe Fixes

Quick answer

E15 on a Bosch dishwasher means the leak protection system has been activated. According to Bosch, a safety switch has detected water in the base of the dishwasher, under the tub. Bosch’s instruction for E15 is short: turn off the water supply to the dishwasher and contact Bosch Customer Support. Unlike a drain code such as E24, E15 is not a code you should try to clear by taking the dishwasher apart. The safe steps below help you stop the water, look for obvious causes, and get the right help.

Quick diagnosis table

Symptom Possible cause First check
E15 or F15 appears on the display Water detected in the dishwasher base Turn off the water supply
Flashing “Active” lights, no code display Leak protection system activated Turn off the water supply
Water leaking from the tub or door, with suds Wrong detergent or spilled rinse aid Check for suds
Water leaking around the door Door seal misaligned or out of its track Check that the seal sits in its track
Water leaking from the tub or door Blocked condensation vent Make sure tall items are not blocking the vent
E15 remains after these checks Water still in the base Contact Bosch Customer Support

Safety first

  • Water and electricity do not mix. Water in the base of the dishwasher can be close to wiring and electrical parts. Switch off the dishwasher’s circuit breaker or unplug it before you touch anything under the door.
  • Close the water supply. Shut the valve that feeds the dishwasher, usually under the kitchen sink.
  • Do not tip, tilt, or pull out the dishwasher to drain the base yourself. Bosch’s UAE support page for E15 advises against trying to resolve the issue at home for health and safety reasons and recommends a service visit.
  • Dry the floor. Wipe up any water on the floor right away to prevent slips and floor damage.

Read our full Safety Disclaimer before you start.

Closed stainless steel Bosch dishwasher under a counter, with the kick-plate area visible near the floor.
A closed Bosch dishwasher in place under the counter, including the kick-plate area along the floor. Photo: Yelderberry / Wikimedia Commons, CC BY-SA 4.0

How to confirm it is E15

  • The display shows E15 (Bosch’s UAE support page notes the same fault may appear as F15).
  • On Bosch models without a code display, Bosch’s U.S. error code list says flashing “Active” lights mean the same thing: the leak protection system has detected water in the base.
  • You may also see water on the floor in front of the dishwasher, but not always. The water can be trapped in the base where you cannot see it.

Before you call for service, write down your model number (E-Nr.) and production number (FD) from the rating plate inside the door. See How to Find Your Model Number.

Side cutaway of a dishwasher showing water collected in the base pan lifting the leak-protection float
Water in the base pan lifts a float, which triggers the leak-protection error. Illustration only.
Metal shutoff valve under a kitchen sink, with copper pipes branching to the faucet and a dishwasher.
An under-sink shutoff valve; the downward copper pipe supplies a dishwasher. Photo: Tomwsulcer / Wikimedia Commons, CC0 1.0

Safe checks for E15

  1. Stop the dishwasher and cut the power. Switch off the breaker or unplug the dishwasher.
  2. Turn off the water supply. This is Bosch’s first instruction for E15.
  3. Check for suds. Open the door and look inside. Bosch’s owner’s manual lists suds as a cause of water leaking from the tub or around the door. Suds usually come from using the wrong detergent (such as hand dish soap) or from overfilled or spilled rinse aid. Use only automatic dishwasher detergent and wipe up any spilled rinse aid.
  4. Check the door seal. The same manual says a door seal that is misaligned or pulled out of its track can cause leaks. Look around the door opening and make sure the seal sits fully in its track. Do not cut or force it.
  5. Check the condensation vent. Bosch’s manual also lists a blocked condensation vent as a leak cause. Make sure tall items, such as trays, are not blocking it.
  6. Look under the sink. With the water still off, check the visible hose connections under the sink for drips or wet spots. Do not loosen or disconnect fittings.
  7. Contact Bosch or a technician. Even if you found a likely cause, water may still be sitting in the base, and Bosch does not give a home procedure for clearing E15. Its instruction is to contact customer support.

Get professional help

E15 means water has already reached the base of the appliance. Finding the exact source, such as a hose, a seal, the pump, or the tub, usually requires removing panels or pulling the dishwasher out of the cabinet, which is a job for a qualified technician. If your dishwasher is under warranty, contact Bosch first.

Need a pro? If any step feels unsafe or the problem keeps coming back, see when to call an appliance technician and how to prepare for the visit.

Parts for E15

E15 does not point to one specific part. The leak can come from several places, so we do not recommend ordering a part until a technician has found the source. If a technician identifies the part, match it to your full model number before you buy.

Related Bosch codes and problems

FAQ

What does E15 mean on a Bosch dishwasher?

Bosch says E15 means the safety switch has detected water in the base of the dishwasher and the leakage protection system has been activated.

Can I keep using the dishwasher with E15?

No. Bosch’s instruction is to turn off the water supply and contact customer support. Running it again could let more water collect in the base.

Can I tilt the dishwasher to drain the base and clear E15?

We do not recommend it. Tilting means pulling the appliance out while it is connected to water, drain, and power, and it does not fix the leak that caused the code. Bosch’s UAE support page advises against home repair for E15 for safety reasons.

Can too many suds cause E15?

Bosch’s owner’s manual lists suds from the wrong detergent or spilled rinse aid as a cause of water leaking from the tub or door. Leaked water can reach the base, so always use automatic dishwasher detergent only.

Is E15 the same as flashing “Active” lights?

On Bosch models without a code display, Bosch’s U.S. error code list describes flashing “Active” lights with the same meaning as E15: water detected in the base.

Need a hand?

A technician can find the source of the leak, dry the base, and replace the right part for your model.

Need a pro? If any step feels unsafe or the problem keeps coming back, see when to call an appliance technician and how to prepare for the visit.

Disclosure: some links in this article are affiliate links. If you buy a part or book a service through them, we may earn a commission at no extra cost to you. Learn more.

Sources

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *