Bosch Dishwasher Error Code E25: Causes and Safe Fixes

Quick answer
E25 on a Bosch dishwasher means the drain pump is blocked or the drain pump cover is loose or missing. That is Bosch’s wording on its U.S. support page for this code. Bosch’s U.S. error code list also tells you to check for a kinked or sharply bent drain hose and a clogged air gap or drain hose. In many cases, cleaning the pump area and making sure the cover clicks fully into place clears the code. If E25 comes back after these checks and a reset, the drain pump itself may need attention.
Quick diagnosis table
| Symptom | Possible cause | First check |
|---|---|---|
| E25 appears after a wash cycle | Blocked drain pump | Clean the filter and check the pump impeller |
| E25 appears right after you cleaned the pump | Pump cover not seated correctly | Make sure the pump cover clicks into place |
| Water stays in the bottom of the tub | Problem in the drain path | Check the drain hose and air gap |
| E25 keeps coming back after every check | Possible drain pump failure | Get a professional diagnosis |
Safety first
- Disconnect power before you reach into the dishwasher. Turn it off and unplug it, or switch off its circuit breaker, before removing the filter or the drain pump cover.
- Wear protective gloves. Bosch warns that broken glass and sharp debris can collect in the pump area.
- Do not use chemical drain cleaners or bleach in the dishwasher. Bosch warns they can damage rubber seals and pump components. Clear blockages by hand.
- Keep towels nearby. Standing water will be in the bottom of the tub.
Read our full Safety Disclaimer before you start.
How to confirm it is E25
- The display shows E25 or E-25, the two forms Bosch lists on its U.S. error code page.
- You may also see water remaining in the bottom of the tub after a cycle.
Before you order any part, write down your full model number (E-Nr.) and production number (FD). On Bosch dishwashers, the rating plate is inside the door. See How to Find Your Model Number.

Safe checks to fix E25
- Turn off and disconnect power. Switch the dishwasher off, then unplug it or turn off the breaker.
- Remove the bottom rack and the filter. The drain pump cover sits under the filter. If you cannot find it, check your owner’s manual.
- Check that the pump cover is not loose. Bosch’s first instruction for E25 is to make sure the cover is fully in place. A cover that is missing or not locked can trigger the code.
- Remove standing water. Wearing gloves, soak up the water in the tub with a sponge.
- Remove the pump cover and clean the pump. Bosch’s U.S. E25 page says to pry the cover off with a spoon until it clicks, grip it and pull upward until you feel resistance, then pull it forward. Bosch pages in other regions add that you should grip the cover by the lug, and that on some models it comes off with a manual screwdriver; never use an electric one. Remove any debris, including broken glass, and make sure the impeller can move freely.
- Reinstall the pump cover until it clicks. Bosch says the click means the cover is completely closed. Then reinstall the filter so it locks in place, with the arrows aligned if your model uses that marking.
- Check the drain hose. Make sure the hose behind the dishwasher or under the sink is not kinked, sharply bent, or crushed.
- Check the air gap and drain hose for clogs. If you have an air gap on the sink, check it for debris. Bosch’s steps are to turn off the appliance, disconnect the drain hose into a bucket, clear any debris, and reconnect it. If you are not comfortable working with under-sink connections, leave this step to a technician.
- Reset and test. Restore power. Bosch’s reset steps: press and hold Reset (on some models labeled “Reset 4 Sec.”) or Start for about 4 seconds. The dishwasher pumps out the remaining water, which takes about a minute, and the cycle is canceled. Then open the door and press On/Off. Finally, run a rinse cycle to check whether it drains.

Still showing E25?
If the code returns after you have cleaned the pump, confirmed the cover clicks into place, and cleared the hose, the problem may be a faulty drain pump or a broken impeller. Bosch recommends professional service if the impeller is broken or the error persists. Its service information notes that debris is a more common cause than a failed pump, and that a pump should be replaced if the impeller is damaged, the pump is noisy, or it still does not work after the drain path is cleared. Stop here if you see water leaking under the dishwasher, smell burning, or are unsure about any step.
Need a pro? If any step feels unsafe or the problem keeps coming back, see when to call an appliance technician and how to prepare for the visit.

Likely replacement part: drain pump
When E25 keeps returning after every cleaning step, the part to suspect next is the drain pump. AppliancePartsPros lists the Bosch drain pump as a fix for E24/E25 and “will not drain” symptoms. Bosch uses different pumps on different models, so match the part to your exact model number before you buy.
Find the right part by your model number: check the drain pump on AppliancePartsPros and confirm it fits your exact model before you order. Not sure where the model number is? See How to Find Your Model Number.
Example: Bosch genuine drain pump, part number 00620774, was listed at $71.51 on AppliancePartsPros.com when we checked on November 21, 2026. Prices change; the retailer’s page shows the current price and whether it fits your model.
Replacing a drain pump means disconnecting the dishwasher from power and water and working underneath or inside the unit. If you have not done this kind of repair before, consider having a technician install it.
Related Bosch codes and problems
- Bosch Dishwasher Error Code E24: Bosch says the dishwasher is not draining properly. Its U.S. error code page gives the same drain-path checks as E25.
- Bosch Dishwasher Error Code E15: Bosch says the safety switch has detected water in the base and the leak protection system is active. Bosch advises turning off the water supply and contacting Bosch Customer Support.
- Dishwasher Not Draining: a general guide for all brands.
FAQ
What does E25 mean on a Bosch dishwasher?
Bosch’s U.S. support page says E25 means the drain pump is blocked or the drain pump cover is loose or missing. Its U.S. error code list also includes a kinked or clogged drain hose and a clogged air gap as checks for this code.
What is the difference between E24 and E25?
Both point to drainage. Bosch’s U.S. error code page gives the same guidance for both. Bosch’s Malaysia support page describes E24 as a drainage obstruction, such as a blocked filter or kinked hose, and E25 as a jammed drain pump impeller or a pump cover that is not clicked into place. Bosch service information also lists a missing or unlocked pump cover among the E25 causes.
Can I just reset the dishwasher to clear E25?
A reset cancels the cycle and pumps out remaining water, but if the cause is still there, the code is likely to come back. Do the cleaning checks first, then reset and run a rinse cycle to test.
Can I pour drain cleaner into the dishwasher?
No. Bosch advises against commercial drain cleaners and bleach because they can damage rubber seals and pump components. Clear the blockage by hand.
When should I call a technician?
Call one if E25 returns after you have cleaned the pump, checked that the cover clicks in, and cleared the hose; if the impeller looks broken; or if there is a leak, a burning smell, or anything you are unsure about.
Need a hand?
If the safe checks did not fix it, a professional can diagnose the pump and replace the right part for your model.
Need a pro? If any step feels unsafe or the problem keeps coming back, see when to call an appliance technician and how to prepare for the visit.
Disclosure: some links in this article are affiliate links. If you buy a part or book a service through them, we may earn a commission at no extra cost to you. Learn more.
Sources
- Bosch (U.S.), E25 Bosch Dishwasher Error Code: https://www.bosch-home.com/us/owner-support/get-support/support-selfhelp-dishwasher-error-e25
- Bosch (U.S.), Dishwasher Error Codes (E24, E25): https://www.bosch-home.com/us/en/c/spotlight/blta5a02e4f244618c3/owner-support/error-codes/dishwashers
- Bosch (U.S.), Cleaning Your Dishwasher Pump: https://www.bosch-home.com/us/owner-support/get-support/support-selfhelp-dishwashers-cleaning-dishwasher-pump
- Bosch (U.S.), How to Reset the Dishwasher: https://www.bosch-home.com/us/en/c/post-purchase/blt40e4d070968e5594/owner-support/get-support/how-to-reset-the-dishwasher-or-stop-a-wash-cycle
- Bosch (Malaysia), Dishwasher Not Draining, E24 and E25: https://www.bosch-home.com.my/en/c/spotlight/bltf81f598efaa53cd4/services/get-support/dishwasher/dishwasher-is-not-draining
- Bosch (Malaysia), Dishwasher Error Code E25: https://www.bosch-home.com.my/services/get-support/dishwasher-error-e25
- Bosch service information, Clean Out Drain System (E23, E24, E25): https://media3.bosch-home.com/Documents/58300000150815_abz_en_b.pdf
- Bosch dishwasher installation instructions (model number and rating plate location): https://media3.bosch-home.com/Documents/9001955705_A.pdf
- AppliancePartsPros, Bosch 00620774 Dishwasher Drain Pump (price checked November 21, 2026): https://www.appliancepartspros.com/bosch-pump-drain-620774-ap5326239.html
